Mini Sensor Controlled Relay
Mini Sensor Controlled Relay

Mini Sensor Controlled Relay

Drive larger relays with low current output from the sensorProbeX+ or sensorProbe2+

If you have an equipment with a relay that you would like to switch based on sensor input, this adapter will output 200mA – 5V DC based on a sensors status. Use this smaller relay as to drive the larger relay on your appliance.

  • Product Code: MSCR

Specifications

Configuration 2 position switch configurations
– 1. 5V and GND contacts (0.2A)
– 2. Free contacts
Output 3 pin termninal Block
– NO, NC, COM
– 5V, GND, COM
Free Contact Voltage 24 VDC, Maximum 30 VDC
120 VAC
Relay Ratings Contact Rating –
  + Contact Rated Load is 1Amp at 24 VDC
  + Contact Rated Load is 1Amp at 120 VAC
Max. Operating Voltage 30 VDC, 120 VAC
Max. Operating Current 1 Amp
Max. Switched Power: 24W / 120VA.
Status Indication LED indication for Relay active state
Operating Temperature -40°C to 80°C
Storage Temperature -40°C to 80°C
Endurance Max. Switching Rate:
 + 300ops./ min. (no load).
 + 30ops./ min. (rated load).
Expected Mechanical Life: 5 million ops (no load).
Expected Electrical Life: 100,000 ops (rated load).
Minimum Load: 1mA @ 1VDC.
   
Interface  
Communications cable RJ-45 jack to sensor using UTP CAT5e/6 cable
Power source Powered by the controller unit. No additional power needed
Power Consumption Typical 150 mWatt, 30 mA
Maximum Cable Length The Sensor Controlled Relay can be extended from the RJ-45 Intelligent Sensor ports on the base units up to 100 feet, or 30 meters using standard CAT5/6 LAN cable
Dimensions 56 x 55 x 33.3 mm
Mounting DIN rail mounting
Screw mounting
Sensor count 1

View Separately

Request a Quotation

Request a quotation from one of our experienced sales staff today.

AKCPMini Sensor Controlled Relay