My sensor readings show that the it should be in a warning state, but I am not getting any alerts. I also noticed another thing that is very strange. I have a temperature sensor connected and it seems to be reading the correct temperature, but why is the temperature in warning status when the temperature reading is within my normal threshold range that I have setup in the web interface?

AKCP AdministratorsensorProbe Series, Support

This most likely due to either your ?Rearm? settings, or your ?Continuous Time for Sensor to be in new Status before accepting new Status? settings. You can check these settings in the Sensors page of the units web interface.

AKCP AdministratorMy sensor readings show that the it should be in a warning state, but I am not getting any alerts. I also noticed another thing that is very strange. I have a temperature sensor connected and it seems to be reading the correct temperature, but why is the temperature in warning status when the temperature reading is within my normal threshold range that I have setup in the web interface?