If the securityProbe hangs during a firmware update, follow these trouble shooting steps below: Unplug all sensors and the Ethernet network cable Boot the system, it will boot into safe mode Once in safe mode (green lights flashing from left to right in cyclical motion), leave the unit without touching anything for 30 minutes The unit should then reboot out of safe mode back into normal mode
Industry Articles and News
Homepage Blog 24
Temperature Monitoring Supports Vaccine Cold Chain
Using temperature sensors to monitor the vaccine cold chain can ensure effective and viable vaccines are delivered.
Homepage Blog 25
Data Center Free Air Cooling
How can Data Centers leverage on geography and local climate to reduce costs and carbon footprint through free air cooling?
Homepage Blog 18
Why Do Vaccines Need Refrigerating
Vaccines have saved millions of lives worldwide. But there are challenges in maintaing their efficacy.
Case Study: Simon Fraser Mechanical Room
Simon Fraser University has constructed a new research data center. It is a 175 rack facility which houses Cedar, the world's 50th largest supercomputer. Construction was recently completed with 107 racks fully populated. AKCP sensor solutions were chosen to monitor the data center and the mechanical room which houses the chilled water plant equipment.
In the initial phase, spot and rope water sensors have been installed in the mechanical room connected with AKCP sensorProbeX+ SNMP enabled base units. The spot and rope water sensors are placed at key points where leaks are most likely to occur. Rope water sensors are laid out along the lengths of pipes or perimeter of an enclosure.