Home » 4-20mAmp Converter

Power Monitoring

4-20mAmp Converter

Bring your industrial sensors into view

Connect third party 4-20mAmp transmitters to your AKCP monitoring platform

VC00 blue and black
third party sensor icon

4-20mAmp

Connect 4-20mAmp transmitters to the sensorProbe+

scaling icon

Scaling

Configure the scale of the input and it’s unit of measurement

Autosense sensor port

Autosense

Automatically configured when connected to the base unit

Alarm Bell icon

Monitoring Alerts

Receive alerts through the sensorProbe+ base unit

The 4-20 mAmp signal converter is used to integrate the sensorProbe with a 4-20 mAmp transmitter. 4-20 mAmp technology is used to communicate analog signals over long distances where electrical interference is a problem. This solution is often used in the process control industry to collect the analog values from a wide array of remote sensors.

Current signals are much less susceptible to noise than voltage signals. A voltage signal can be converted to current and then broadcast over a long distance before it is converted back to voltage and read by the sensorProbe.

4-20 mAmp transmitters are common in the industry for use with high quality sensors. With the 4-20 mAmp converter these sensors can now be integrated into the sensorProbe enhancing their value with the addition of graphing, web interface, email interface, thresholds, and limits.

  • Converts current levels from 4 – 20 mA to 0.8 – 4.0 V voltage levels
  • Maximum linearity of ± 0.09%
  • Maximum accuracy of ± 0.15%
  • Operates from a single +5 V DC Power Supply which is powered by the sensorProbe
  • Fully Rated Over the -40°C to 85°C Industrial Temperature Range
  • 2 LED show status of the current loop and the power supply
  • Up to two I V converters per sensorProbe2, 8 per sensorProbe8
Air Handling
Water Quality
process instrumentation
Process Instrumentation
Measuring Specifications 
Input2 pin Phoenix connector : 4-20mA Iin(+) and Iin(-) for current loop
Output Voltage Range+0.4 V to +2.0 V
Linearity± 0.09 % Full Scale, Maximum
Accuracy± 0.15% Full Scale (± 0.3% Full Scale, Maximum)
Status IndicationLED indication for current detection
LED indication for power
Electricalno galvanic isolation
ComponentsManufactured using highly integrated, low power surface mount technology to ensure long term reliability.
Operating EnvironmentTemperature : Min. -35° C – Max.80° C
Humidity: Min. 20% – Max. 80% (Non-Condensing)
  
Interface 
Communications cableRJ-45 jack to sensor using UTP CAT5e/6 cable
Power sourcePowered by the controller unit. No additional power needed
Power ConsumptionTypical 120 mWatt, 24mA
Maximum Cable Length The 4-20mA sensor Adaptor can be extended from the RJ-45 Intelligent Sensor ports on the base units up to 50 feet, or 15 meters using standard CAT5/6 LAN cable
Dimensions65(W) x 62(H) x 15(D) mm
MountingDIN rail mounting
Screw mounting
Sensor count1

 

VC00 tech drawing

Schedule a Demo With Us

Find out how we can Protect, Monitor and Optimize your Data Center

AKCP data center monitoring sensors

Interested in our FREE Data Center PUE check?

Contact us below and schedule a 15 minute consultation

Thank you for your submission!

One of our team members will reach out within 24 hours.

Contact AKCP