Smoke Detector
Monitoring for developing smoke is an essential aspect in the security and safety of any facility.
AKCP has designed a smoke sensor specifically for use with its sensorProbe+ and securityProbe product line. These smoke detectors are easy to install and configure and can be used in conjunction with all other of AKCP’s alerting features.
- Accurate, cost effective Smoke Detector
- On/Off alarm signal of Smoke Detected
- LED indicates the status of Smoke Detector
- Low profile design for ceiling mounting for maximum smoke detection
- Sensor type – open/closed contact switch
- Includes disconnect alarm that checks that the sensor is securely plugged into the sensor/securityProbe
- The smoke detector can also be attached to dry contacts of a X20 or X60 unit
- With internal battery as backup the sensor/securityProbe will still work as a smoke detector on its own
| Measurement Range | Smoke or No Smoke |
| Sensor Type | Photoelectric Detector Type |
| Suitable for installation to BS 5839 pt 6 Grade F | |
| Output Type | Open/Closed contact switch |
| Features | Loud piercing 85db alarm at 3m |
| Full function test button | |
| Alarm auto-reset | |
| Insect resistant chamber | |
| Low profile design for ceiling mounting for maximum smoke detection | |
| Measurement Rate | Multiple readings every second |
| Indication | LED for Status Strobe Light when Smoke is detected |
| Operating Temperature | -20 °C~60 °C 4 °F~140 °F |
| Interface | |
| Communications Cable | RJ-45 jack to sensor using UTP Cat 5 wire |
| Communications Cable Max. length | The Smoke Detector can be extended from the RJ-45 Intelligent Sensor ports on the base units up to 500 feet, or 150 meters using standard CAT5/6 LAN cable |
| Power Source | Interface module powered by the base unit. Internal battery inside smoke detector. |
| Full autosense including disconnect alarm | |
| Power Consumption | Typical 290 mWatt, 58mA |
| Dimensions | Diameter 100mm, height 28mm |
| Mounting | Screw mounting |
| Sensor count | 1 |
