Secure and Protect your computer cabinet assets with the AKCP RFID Swing Handle Cabinet Lock
Secure and Protect IT Cabinet Assets
RFID Cabinet Locks (SHL) have a universal fit for most industry standard cabinet panel preparations. Easy to install, connects to any sensorProbe+ base unit. Complete control over your cabinet security.
Manage who has access to your cabinets, and when. AKCPro Server provides a complete audited trail of access events on a per cabinet or employee basis. Know who accessed which cabinet and when. Swing handles can be unlocked with a manual key override, an authorized RFID card, or remotely under software control. The RFID Cabinet Lock is part of our Rack+ intelligent computer cabinet solution, combine with In-Line Power Meters, Cabinet Thermal Maps, Sensor Status Lights and LCD displays. Up to 12 RFID cabinet locks can be connected to a single SPX+ device, spreading the cost of the controller over multiple cabinets for a cost effective solution.
RFID Cabinet Lock Features
Up to 12 RFID Cabinet Locks can be connected to a single SPX+, monitor and control access for 12 cabinets, or 6 cabinets (front and rear doors) from a single IP address. Spread the cost of the controller across multiple cabinets for a cost-effective installation. RFID Cabinet Locks can be placed up to 15 meters cable length from the SPX+ base unit.
|Supported Cards :||EM-Card, 125Khz Proximity cards, 26bits
|Proximity Reading Range :||0-3cm|
|Access Control :||Up to 500 users|
|Ambient Temperature :||-25°C to 75°C|
|Ambient Humidity :||10%-90%|
|Built-in :||RFID Antenna, Motor|
|Fail-Secure :||Integrated key lock for manual override|
|LED Indicator :||RGB Color LED : Lock status and Access Control status|
|Locking Control :||Remote lock and unlock from the sensorProbe+ unit via Web Interface, SNMP or AKCPro Server
Calendar enabled locking and unlocking control
Notification locking and unlocking control
|Communications cable :||RJ-45 jack to sensor using UTP CAT5e/6 cable|
|Power source :||Powered by the sensorProbe+ family units. No additional power needed|
|Working Voltage :||DC 5V|
|Power Consumption :||Typical 0.35 mWatt, 70 mA
Peak 1.75 mWatt, 350 mA
|Communication Distance :||Run length is 12 feet (5 meters) with approved low capacitance shielded cable or UTP|
|Important Note:||sensorProbe+ units auto-detects the presence of the RFID Swing Handle Lock sensor|
|Up to 12 RFID Swing Handle Lock sensors per sensorProbe+ unit|
|– The RFID Swing Handle Lock sensor is only compatible with the sensorProbe+ platform units.
– When plugging the first time or after upgrading a sensorProbe+ unit, the sensor’s firmware might be upgraded by the unit and not be available right away. Firmware update must be done on the main module first 4 sensor ports only.
The AKCP RFID Swing Handle is simple to install on most industry standard cabinets. The video below shows how easy this is.