Single Port Temperature and Humidity Sensor
Dual sensor, 2 sensors on one port
Combining temperature and humidity into the one sensor frees up an additional intelligent sensor port on your base unit.
- Product Code: THS01 or THS00 for extendable version
- 2 variations available
- Powered by the base unit
- Temperature and Humidity Monitoring on a single sensor port
- Own SNMP OID for data collection via a network
- Temperature measurement from -40ºC – +75ºC
- Relative Humidity measurement from 0% – 100%
- Powered by base unit, no additional power needed
Setup is simple with the sensorProbe, sensorProbe+ and securityProbe autosense function. Once plugged into the intelligent sensor port the base unit automatically detects the presence of the sensor and configures it for you.
Temperature and humidity for data center monitoring, remote sites and industrial controls.
All you need to do is set your thresholds for low and high warning and critical parameters. The built in graphing function of the base unit gives you a pattern of temperature or humidity trends over time.
|Measurement Range||-55°C to +75°C
-67°F to +167°F
|Measurement Resolution||sensorProbe+ series
|Measurement Accuracy||sensorProbe+ series and securityProbe series
±0.5°C accuracy from -10°C to +75°C
±0.9°F accuracy from +14°F to +167°F
±1°C accuracy from -10°C to +75°C
±1°F accuracy from +14°F to +167°F
|Measurement range||0 to 100% Relative humidity|
|Resolution||1%RH increments, 0.01%RH sensor reading|
|Accuracy at||At 25°C
Min : ±2%RH
Max : ±5% RH
|Communications cable||RJ-45 jack to sensor using UTP CAT5e/6 cable|
|Power source||Powered by the base units. No additional power needed|
|Power Consumption||Typical 17.25mWatt, 1.45mA|
|Maximum Cable Length||Run length
THS00 – SPX+ 1000 feet (300 meters) with approved low capacitance shielded UTP cable.
THS00 – SP2+ – 600 feet (180 meters) with approved low capacitance shielded UTP cable.
THS01 – 100ft (30 meters)
|Sensor type||Semiconductor, microprocessor controlled|
|Dimensions||56 x 55 x 33.3 mm|
|Mounting||DIN rail mounting
|Sensor count (NIST2/NIST4)||3|
|Important Note||The fixed one foot type or THS01 are not designed to be extended. If you need to extend these sensors then you need to use the THS00 (remote type). We also do not recommend you trying to connect any of our AKCP sensors including the temperature and dual temp humidity sensors though patch panels or using the RJ-45 couplers to extend them. Please see the temperature sensors product manual or FAQ in our knowledge base for more details regarding this.|
|Compatibility||THSxx-NIST2 and THSxx-NIST4 compatible with sensorProbe+ series only|
Fixed length temperature and humidity sensor with 1ft of cable attached
Variable length temperature and humidity sensor. Ships with free 5ft CAT5 cable, user can extend up to 1,000ft.
Standards incorporated to establish this comparison are NIST and NPL traceable.
Our Single Port Temperature/Humidity Sensor comply with RoHS and WEEE requirements. There is no substance to be declared.