Yes, you can simply press the red reset button on the back of the unit once and the unit will announce the IP address through the speaker.
Industry Articles and News
Homepage Blog 33
Concrete Curing Monitoring
As concrete cures it goes through an exothermic reaction. The ambient temperature affects the rate of the reaction and time to obtain full strength.
Homepage Blog 18
Why Do Vaccines Need Refrigerating
Vaccines have saved millions of lives worldwide. But there are challenges in maintaing their efficacy.
Homepage Blog 4
W.H.O Guidance on Storage and Transport of Pharmaceuticals
30% of scrapped pharmaceutical products are the result of temperature excursions during transport.
Case Study: Simon Fraser Mechanical Room
Simon Fraser University has constructed a new research data center. It is a 175 rack facility which houses Cedar, the world's 50th largest supercomputer. Construction was recently completed with 107 racks fully populated. AKCP sensor solutions were chosen to monitor the data center and the mechanical room which houses the chilled water plant equipment.
In the initial phase, spot and rope water sensors have been installed in the mechanical room connected with AKCP sensorProbeX+ SNMP enabled base units. The spot and rope water sensors are placed at key points where leaks are most likely to occur. Rope water sensors are laid out along the lengths of pipes or perimeter of an enclosure.
