Secure and Protect your computer cabinet assets with the AKCP RFID Swing Handle Cabinet Lock
Secure and Protect Computer Cabinet Assets
RFID Swing Handle Cabinet Locks (SHL) have a universal fit for most industry standard cabinet panel preperations. Easy to install, connects to any sensorProbe+ base unit. Complete control over your cabinet security.
Manage who has access to your cabinets, and when. AKCPro Server provides a compelte audited trail of access events on a per cabinet or employee basis. Know who accessed which cabinet and when. Swing handles can be unliocked with a manual key override, an authorized RFID card, or remotely under software control. The SHL is part of our Rack+ intelligent computer cabinet solution, combine with In-Line Power Meters, Cabinet Thermal Maps, Sensor Status Lights and LCD displays. Up to 12 SHL can be connected to a single SPX+ device, spreading the cost of the controller over multiple cabinets for a cost effective solution.
Swing Handle Lock Features
Up to 12 RFID Swing Handle Locks can be connected to a single SPX+, monitor and control access for 12 cabinets, or 6 cabinets (front and rear doors) from a single IP address. Spread the cost of the controller across multiple cabinets for a cost effective installation. RFID Swing Handle Locks can be placed up to 15 meters cable length from the SPX+ base unit.
|Supported Cards :||EM-Card, 125Khz Proximity cards, 26bits
|Proximity Reading Range :||0-3cm|
|Access Control :||Up to 500 users|
|Ambient Temperature :||-25°C to 75°C|
|Ambient Humidity :||10%-90%|
|Built-in :||RFID Antenna, Motor|
|Fail-Secure :||Integrated key lock for manual override|
|LED Indicator :||RGB Color LED : Lock status and Access Control status|
|Locking Control :||Remote lock and unlock from the sensorProbe+ unit via Web Interface, SNMP or AKCPro Server
Calendar enabled locking and unlocking control
Notification locking and unlocking control
|Communications cable :||RJ-45 jack to sensor using UTP CAT5e/6 cable|
|Power source :||Powered by the sensorProbe+ familiy units. No additional power needed|
|Working Voltage :||DC 5V|
|Power Consumption :||Typical 0.35 mWatt, 70 mA
Peak 1.75 mWatt, 350 mA
|Communication Distance :||Run length is 12 feet (5 meters) with approved low capacitance shielded cable or UTP|
|Important Note:||sensorProbe+ units auto detects the presence of the RFID Swing Handle Lock sensor|
|Up to 12 RFID Swing Handle Lock sensors per sensorProbe+ unit|
|– The RFID Swing Handle Lock sensor is only compatible with the sensorProbe+ platform units.
– When plugging the first time or after upgrading a sensorProbe+ unit, the sensor’s firmware might be upgraded by the unit and not be available right away.
The AKCP RFID Swing Handle is simple to install on most industry standard cabinets. The video below shows how easy this is.